• Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set
  • Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set
  • Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set
  • Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set
  • Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set
1 5
SKU: DEK03067

Red & Black Heavy-Duty Top Post Epoxy Coated Terminals Set

$6.08 USD
$6.08 USD
Sale Sold out

Product Description

Deka # 03067 

Heavy Duty Red & Black Replacement 

Epoxy Top Post Battery Terminals

Includes (1) Red & (1) Black Terminal for Positive & Negative connection.

                    
03067 East Penn Battery Terminal
  • Type : Positive/ Negative
  • Positions : 2 Position
  • Input/output : 6/1 Gauge
  • Digital Voltage Meter Type : No Digital Voltage Meter
  • Finish : Bare
  • Color : Red and Black
  • Material : Lead
  • Insulating Cover Color : No Insulating Cover

Instructions for installing battery terminals
  1. Always disconnect grounded cable before replacing terminal on either cable.
  2. Remove old terminal by cutting or sawing as close to terminal as possible
  3. Strip cable insulation approximately 3/4" Back from cable end.
  4. Loosen Back Plate on terminal by unscrewing two back plate bolts. smaller cables, the back plate may be turned over to assure a tigher fit.
  5. Insert bare end of cable into treaded opening below back plate and tighten both bolts firmly. Caution: sufficient pressure must be applied against bare wire. No insulation can be under back plate. bare wire should extend 1/8" beyond terminal
  6. clean battery post
  7. Always replace ground cable connection last. Place terminal over post and tighten firmly
NOTE: Do not hammer terminal onto post. if it is to tight, spread terminal slightly.